3com PS Hub 40 User Manual
DUA1640-5AAA02
B-4
A
PPENDIX
B: M
ANAGEMENT
U
SING
Q
UICK
C
ONFIG
M
ANAGER
Running Quick
Config Manager
Config Manager
Whenever you want to start the Quick Config Manager application,
double-click on the Quick Configuration Manager icon.
double-click on the Quick Configuration Manager icon.
CAUTION: Do not run Quick Config Manager in parallel with any other
Transcend management application.
Transcend management application.
Before you can manage the stack, you must make a management
connection to the stack. If you are going to manage over a serial link
from your management station, Quick Config Manager uses COM1 as
the default serial port. You can change this by editing the following line
under the [slip] subsection of the QUICKMGR.INI file:
connection to the stack. If you are going to manage over a serial link
from your management station, Quick Config Manager uses COM1 as
the default serial port. You can change this by editing the following line
under the [slip] subsection of the QUICKMGR.INI file:
SerialAttrib=COM1:9600,n,8,1
Editing it to
SerialAttrib=COM2:9600,n,8,1
changes the default serial
port to COM2.
Before Managing with Quick Config Manager, you must ensure that
your management equipment and the hub have been set up, refer to
“Quick Config Manager” on page 5-13.
your management equipment and the hub have been set up, refer to
“Quick Config Manager” on page 5-13.
Configuring
Multiple Stacks
Multiple Stacks
There is a special feature which enables you to refresh your
management communication when connecting your management
station to different stacks. This means that you do not need to close
and re-open Quick Config Manager, which is particularly useful if you
have many separate stacks that need configuring or monitoring.
management communication when connecting your management
station to different stacks. This means that you do not need to close
and re-open Quick Config Manager, which is particularly useful if you
have many separate stacks that need configuring or monitoring.
To do this:
1 Make your serial connection to the new stack.
2 From the File menu, select Reset View.
Quick Config Manager closes any windows that are open in
preparation for the new management session.
preparation for the new management session.