3com 4210 User Manual

Configuring GVRP

# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port. # The
configuration on Switch C is similar to that on Switch A.

For simplicity, the following provides only configuration steps. For configuration
commands, refer to “Configure Switch C” on page 34.

■

Configure Switch D

# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port.

# Create VLAN 8.

■

Configure Switch E

# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port.

# Create VLAN 5 and VLAN 7.

■

Display the static VLAN registration information on Switch A, Switch B, and
Switch C.

# Display the dynamic VLAN information on Switch A.

[SwitchA] display vlan dynamic

Total 3 dynamic VLAN exist(s).

The following dynamic VLANs exist:

5, 7, 8,

# Display the dynamic VLAN information on Switch B.

[SwitchB] display vlan dynamic

Total 3 dynamic VLAN exist(s).

The following dynamic VLANs exist:

5, 7, 8,

# Display the dynamic VLAN information on Switch E.

[SwitchE] display vlan dynamic

Total 1 dynamic VLAN exist(s).

The following dynamic VLANs exist:

■

Set the registration mode of Ethernet 1/0/1 on Switch E to fixed, and display
the dynamic VLAN registration information on Switch A, Switch B, and Switch
E.

# Set the registration mode of Ethernet 1/0/1 on Switch E to fixed.

[SwitchE] interface Ethernet 1/0/1

[SwitchE-Ethernet1/0/1] gvrp registration fixed

# Display the dynamic VLAN information on Switch A.