Enterasys Networks ELS10-27TX User Manual
6-2
Configuring Workgroups Using SNMP
6.2 WORKGROUP CONFIGURATION PROCEDURES
You should have a familiarity with networking concepts and principles. In
addition, a basic understanding of SNMP is helpful. SNMP Configuration
information is shown on the following pages.
addition, a basic understanding of SNMP is helpful. SNMP Configuration
information is shown on the following pages.
To configure workgroups using SNMP, proceed as follows:
When writing to the els10-27WorkGroupType entry, the following checks are
made:
made:
•
If the els10-27WorkGroupNumber is less than 1 or greater then 8, the
command will be aborted.
command will be aborted.
•
If the els10-27WorkGroupName field is blank, the command will be aborted.
•
If the els10-27WorkGroupPorts is empty, the command will be aborted.
•
If the els10-27WorkGroupType field is not 3 or 4, the command will be
aborted.
aborted.
Step
Action
1
Read els10-27WorkGroupCurrentCount. This will tell you if another
workgroup can be created.
workgroup can be created.
If the value is less than 8, another workgroup can be created.
2
Read els10-27WorkGroupNextNumber. This is the next available
index into the workgroup table.
index into the workgroup table.
This number should be written to els10-27WorkGroupNumber.
3
Write the number returned from els10-27WorkGroupNextNumber
to els10-27WorkGroupNumber.
to els10-27WorkGroupNumber.
4
Write the new workgroup name to els10-27WorkGroupName.
5
Write the list of ports to be included in the workgroup, to els10-
27WorkGroupPorts.
27WorkGroupPorts.
6
Write a value of 3 to els10-27WorkGroupType.