3com 4500 PWR 26-PORT User Manual

 Specifies the MAC address of a user. Where, 

takes on the hexadecimal format of 

.

 Allows/disallows the local users to enable the idle-cut 

function. (The specific data for this function depends on the configuration of the 
ISP domain where the users are located.) The argument 

 defines the 

idle-cut time, which is in the range of 60 to 7200 seconds.

 Specifies the maximum number of users who 

access the device using the current user name. The argument 

 is 

in the range of 1 to 1024.

 Sets the VLAN attribute of user, in other words, the VLAN to which 

a user belongs. The argument 

 is an integer in the range of 1 to 4094.

 Sets the port binding attribute of user.

 The IP address of the access server in the event of binding a 

remote port with a user. The argument 

 is an IP address in dotted 

decimal format and defaults to 127.0.0.1.

 Sets the port to which a user is bound. The argument 

 is 

represented by “SlotNumber SubSlotNumber PortNumber”. If any of these three 
items is absent, the value 0 will be used to replace it.

Use the 

 command to configure some attributes for specified local user. 

Use the 

 command to cancel the attributes that have been 

defined for this local user.

It should be noted that the argument nas-ip must be defined for a user bound 
with a remote port, which is unnecessary, however, in the event of a user bound 
with a local port.

Related command: 

.

To configure the IP address 10.110.50.1 to the user JohnQ, enter the following:

<4500> system-view

System View: return to User View with Ctrl+Z.

[4500]local-user JohnQ

New local user added.

[4500-luser-JohnQ]ip 10.110.50.1

domain domain-name | interface interface-type interface-number | ip 

ip-address | mac mac-address | radius-scheme radius-scheme-name | 

vlan vlanid | ucibindex ucib-index | user-name user-name }

System View