3com 4500 PWR 26-PORT User Manual

For a Switch, each supplicant belongs to an ISP domain. The system supports up to 
16 ISP domains.  If a user has not reported its ISP domain name, the system will 
put it into the default domain. 

When this command is used, if the specified ISP domain does not exist, the system 
will create a new ISP domain. All the ISP domains are in the 

 state when 

they are created. 

Related commands: 

, 

, 

, 

.

To create a new ISP domain, marlboro.net, and enters its view, enter the following:

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]domain marlboro.net

New Domain added.

[4500-isp-marlboro.net]

idle-cut { disable | enable minute flow }

ISP Domain View

 means disabling the user to use idle-cut function .

 means enabling the user to use the function. 

 Specifies the maximum idle time, ranging from 1 to 120 and measured in 

minutes. 

The minimum data traffic, ranging from 1 to 10,240,000 and measured in 

bytes.

Use the 

command to configure the user template in the current ISP 

domain. 

By default, after an ISP domain is created, this attribute in user template is 

, that is, the user idle-cut is disabled. 

The user template is a set of default user attributes. If a user requesting for the 
network service does not have some required attributes, the corresponding 
attributes in the template will be endeavored to him as default ones. The user 
template of the Switch you are using may only provide user idle-cut settings. After 
a user is authenticated, if the idle-cut is configured to enable or disable by neither 
the user nor the RADIUS server, the user will adopt the idle-cut state in the 
template. 

Because a user template only works in one ISP domain, it is necessary to configure 
user template attributes for users from different ISP domain respectively.