3com 4500 PWR 26-PORT User Manual

C

HAPTER

 2: U

SING

 P

ORT

 C

OMMANDS

 { interface_type interface_number 

| interface_name } [ to { interface_type interface-num | 

 } ]

Any view

 

{ interface_type interface_ num | interface_name } [ to { 

 | interface_name } ]:

 Specifies ports. You 

can specify multiple sequential ports with the 

 parameter, instead of specifying 

only one port.

 Specifies port name, in the format of 

 Specifies port type and 

 port number. 

For more information, see the parameter item for the 

command.

Use the 

 command to view detailed link 

aggregation information at a designated port, including aggregation group ID for 
the port, port priority, operation key, LACP state flag, partner information (system 
ID, port number, port priority, operation key, LACP state flag, LACP packet 
statistics).

Note that unlike a dynamic aggregation, a manual aggregation has no protocol to 
get the remote peer information of the partner. Therefore, every item for the 
remote peer is 0. This does not indicate the actual state of the remote peer.

To display detailed link aggregation information of a link aggregation member 
port, enter the following:

<4500>display link-aggregation interface ethernet4/0/1

If the aggregation has been created manually, the display will be similar to the 
following:

Ethernet4/0/1:

   Attached AggID: 1

   Local:

     Port-Priority: 32768, Oper key: 1, Flag: 0x00

   Remote:

     System ID: 0x0, 0000-0000-0000

     Port Number: 0, Port-Priority: 0, Oper-key: 0, Flag: 0x00

If the aggregation is static or dynamic, the display will be similar to the following:

<4500>display link-aggregation interface ethernet4/0/1

Ethernet4/0/1:

   Attached AggID: 20