DELL PC7024 User Manual

IPv6 Routing Commands

Use the show ipv6 route command in User EXEC or Privileged EXEC mode 

to display the IPv6 routing table. The output of the command also displays 

the IPv6 address of the default gateway and the default route associated with 

the gateway.

show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol | 

interface-type interface-number] [best]

This command has no default configuration. 

User EXEC, Privileged EXEC modes

This command has no user guidelines.

ipv6-address

Specifies an IPv6 address for which the best-matching route 

would be displayed.

protocol

Specifies the protocol that installed the routes. Is one of the 

following keywords: connected, ospf, static.

ipv6-prefix/ prefix-

length

Specifies an IPv6 network for which the matching route would 

be displayed.

interface-type 

interface-number

Valid IPv6 interface. Specifies that the routes with next-hops on 

the selected interface be displayed. Supported interface types 

are VLAN, Tunnel, and Loopback.

best

Specifies that only the best routes are displayed. If the 

connected keyword is selected for protocol, the best option is 

not available because there are no best or non-best connected 

routes.

2CSPC4.XCT-SWUM2XX1.book  Page 1054  Monday, October 3, 2011  11:05 AM