DELL PC7024 User Manual
OSPF Commands
1111
Example
The following example prevents the Summary LSA from being advertised
into the area 3 NSSA.
console(config-router)#area 3 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPF Configuration mode to
create the OSPF virtual interface for the specified area-id and neighbor
router. To remove the link, use the no form of the command. Use the optional
parameters to configure authentication, dead-interval, hello-interval,
retransmit-interval and transmit-delay. If the area has not been previously
created, it is created by this command. If the area already exists, the virtual-
link information is added or modified.
Syntax
area
area-id virtual-link router-id [authentication [message-digest | null]]
[
hello-interval seconds] [retransmit-interval seconds] [transmit-delay
seconds] [dead-interval seconds] [[authentication-key key] | [message-
digest-key
key-id md5 key]]
no
area area-id virtual-link router-id [authentication [message-digest | null]]
[
hello-interval] [retransmit-interval] [transmit-delay] [dead-interval]
[[
authentication-key] | [message-digest-key]]
Parameter Description
Parameter
Description
area-id
Identifies the OSPF stub area to configure. (Range: IP address
or decimal from 0-4294967295)
router-id
Valid IP address.
authentication
Specifies authentication type.
message-digest
Specifies that message-digest authentication is used.
null
No authentication is used. Overrides password or message-
digest authentication if configured for the area.
2CSPC4.XCT-SWUM2XX1.book Page 1111 Monday, October 3, 2011 11:05 AM