DELL PC7024 User Manual
Management ACL Commands
1417
Management access list names can consist of any printable character,
including blanks. Enclose the name in quotes to embed blanks in the name.
Examples
The following example shows how to configure two management interfaces,
gigabit Ethernet 1/0/1 and gigabit Ethernet 2/0/9.
console(config)#management access-list mlist
console(config-macal)# permit gigabitethernet 1/0/1 priority 1
console(config-macal)# permit gigabitethernet 2/0/9 priority 1
console(config-macal)# exit
console(config)#management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, gigabit Ethernet 1/0/1 and
gigabit Ethernet 2/0/9.
console(config)# management access-list mlist
console(config-macal)# deny gigabitethernet 1/0/1 priority 1
console(config-macal)# deny gigabitethernet 2/0/9 priority 2
console(config-macal)# permit priority 2
console(config-macal)# exit
console(config) # management access-class mlist
permit (management)
Use the permit command in Management Access-List configuration mode to
set conditions for the management access list.
Syntax
permit ip-source
ip-address [mask mask | prefix-length] [gigabitethernet
unit/slot/port | vlan vlan-id | port-channel port-channel-number |
tengigabitethernet
unit/slot/port] [ service service ] [ priority priority-value ]
permit {gigabitethernet
unit/slot/port | vlan vlan-id | port-channel port-
channel-number | tengigabitethernet
unit/slot/port} [service service]
[priority
priority-value]
permit service
service [priority priority-value]
permit priority
priority-value
2CSPC4.XCT-SWUM2XX1.book Page 1417 Monday, October 3, 2011 11:05 AM