DELL PC7024 User Manual
758
Spanning Tree Commands
spanning-tree priority
Use the spanning-tree priority command in Global Configuration mode to
configure the spanning-tree priority. The priority value is used to determine
which bridge is elected as the root bridge. To reset the default spanning-tree
priority use the no form of this command.
Syntax
spanning-tree priority
priority
no spanning-tree priority
•
priority — Priority of the bridge. (Range: 0–61440)
Default Configuration
The default bridge priority for IEEE STP is 32768.
Command Mode
Global Configuration mode
User Guidelines
The priority value must be a multiple of 4096.
The switch with the lowest priority is the root of the spanning tree.
The switch with the lowest priority is the root of the spanning tree.
Example
The following example configures spanning-tree priority to 12288.
console(config)#spanning-tree priority 12288
spanning-tree tcnguard
Use the spanning-tree tcnguard command to prevent a port from propagating
topology change notifications. Use the “no” form of the command to enable
TCN propagation.
Syntax
spanning-tree tcnguard
no spanning-tree tcnguard
no spanning-tree tcnguard
2CSPC4.XCT-SWUM2XX1.book Page 758 Monday, October 3, 2011 11:05 AM