DELL N3000 User Manual

Page of 1460
1026
Configuring Routing Interfaces
Default Routing Interface Values
By default, no routing interfaces are configured. 
When you create a VLAN, no IP address is configured, and DHCP is disabled. 
After you configure an IP address on a VLAN or loopback interface, the VLAN 
interface is available for L3 routing (if enabled) and is capable of resolved 
ARPs and responding to pings, and the interface has the default configuration 
shown in Table 31-1.
Most interface configuration parameters are not applicable to loopback 
interfaces, so you cannot change the default values. However, when you create 
a loopback interface, the default values are similar to those of VLAN routing 
interfaces, as Table 31-1 shows.
When you create a tunnel, it has the default values shown in Table 31-2
Table 31-1. VLAN Routing Interface and Loopback Interface Defaults
Parameter
Default Value
Forward Net Directed Broadcasts
Disabled
Encapsulation Type
Ethernet (N/A for loopbacks)
Proxy Arp
Enabled
Local Proxy Arp
Disabled
IP MTU
1500
Bandwidth
Not configured.
Destination Unreachables
Enabled
ICMP Redirects
Enabled
Table 31-2. Tunnel Interface Defaults
Parameter
Default Value
Tunnel mode
6-in-4 configured
Link Local Only Mode
Disabled
Source address
None
Destination address
0.0.0.0