DELL N3000 User Manual

Page of 1460
Configuring OSPF and OSPFv3
1169
Configuring OSPFv3 Interface Settings
Beginning in Privileged EXEC mode, use the following commands to 
configure per-interface OSPFv3 settings.
Command
Purpose
configure
Enter global configuration mode.
interface vlan 
vlan-id
Enter Interface Configuration mode for the specified 
VLAN.
ipv6 ospf areaid 
area-id
  Enables OSPFv3 on the interface and sets the area ID of 
an interface. This command supersedes the effects of 
network area command.
The 
area-id
 variable is the ID of the area (Range: IP 
address or decimal from 0 –4294967295)
ipv6 ospf priority 
number-value
Set the OSPFv3 priority for the interface. The 
number-
value 
variable specifies the priority of an interface (Range: 
0 to 255). 
The default priority is 1, which is the highest router 
priority. A value of 0 indicates that the router is not 
eligible to become the designated router on this network.
ipv6 ospf retransmit-
interval 
seconds
Set the OSPFv3 retransmit interval for the interface. 
The 
seconds
 variable is the number of seconds between 
link-state advertisements for adjacencies belonging to this 
router interface. 
This value is also used when retransmitting database 
descriptions and link-state request packets. Valid values 
range from 0 to 3600 seconds (1 hour).
ipv6 ospf hello-interval 
seconds
Set the OSPFv3 hello interval for the interface. This 
parameter must be the same for all routers attached to a 
network. 
The 
seconds
 variable indicates the number of seconds to 
wait before sending Hello packets from the interface. 
(Range: 1–65535).