DELL N3000 User Manual

Page of 1460
710
Configuring VLANs
Configuring a Voice VLAN
The commands in this example create a VLAN for voice traffic with a VLAN 
ID of 25. Port 10 is set to an 802.1Q VLAN. In in this example, there are 
multiple devices connected to port 10, so the port must be in general mode in 
order to enable MAC-based 802.1X authentication. Next, Voice VLAN is 
enabled on the port with the Voice VLAN ID set to 25. Finally, Voice VLAN 
authentication is disabled on port 10 because the phone connected to that 
port does not support 802.1X authentication. All other devices are required to 
use 802.1X authentication for network access. For more information about 
To configure the switch:
Create the voice VLAN.
console#configure
console(config)#vlan 25
console(config-vlan25)#exit
Enable the Voice VLAN feature on the switch.
console(config)#voice vlan
Configure port 10 to be in general mode.
console(config)#interface gi1/0/10
console(config-if-Gi1/0/10)#switchport mode 
general
Enable port-based 802.1X authentication on the port. This step is required 
only if there are multiple devices that use port-based authentication 
connected to the port.
console(config-if-Gi1/0/10)#dot1x port-control 
mac-based
Enable the voice VLAN feature on the interface
console(config-if-Gi1/0/10)#voice vlan 25
NOTE: 
In an environment where the IP phone uses LLDP-MED to obtain 
configuration information, an additional step to enable LLDP-MED on the 
interface would be required by issuing the lldp med command in Interface 
Configuration mode.