DELL N3000 User Manual

Page of 1460
Configuring Link Aggregation
927
Configuring LACP Parameters
Beginning in Privileged EXEC mode, use the following commands to 
configure system and per-port LACP parameters.
hashing-mode 
mode
Set the hashing algorithm on the LAG. 
The 
mode
 value is a number from 1 to 7. The numbers 
correspond to the following algorithms:
• 1 — Source MAC, VLAN, EtherType, source module, and 
port ID
• 2 — Destination MAC, VLAN, EtherType, source 
module, and port ID
• 3 — Source IP and source TCP/UDP port
• 4 — Destination IP and destination TCP/UDP port
• 5 — Source/destination MAC, VLAN, EtherType, and 
source MODID/port
• 6 — Source/destination IP and source/destination 
TCP/UDP port
• 7 — Enhanced hashing mode
CTRL + Z
Exit to Privileged EXEC mode.
show interfaces port-
channel [
port-channel 
number
]
View LAG information for the specified LAG or for all 
LAGs.
show statistics port-
channel 
port-channel-
number
View interface statistics for the specified LAG.
Command
Purpose
configure
Enter global configuration mode.
lacp system-priority 
value
Set the Link Aggregation Control Protocol priority for the 
switch. the priority value range is 1–65535.
Command
Purpose