DELL N3000 User Manual

Page of 1460
Configuring Link Aggregation
953
transmitted with the source MAC address as the physical MAC address and 
not the virtual MAC address. In the example in Figure 28-17, if the virtual 
MAC address is used as the source MAC address in the ARP from P to A, then 
S will consume the packet, as it is operationally a VRRP master too. The 
packet is forwarded to P if the physical MAC address is used.
Note that the VLANs connecting A and B to the MLAG peers are extended to 
R1. P and S do not actually route packets. Within the MLAG domain, packets 
are switched only.
Caveats and Limitations
Traffic to and from non-redundant ports is filtered and never crosses the 
MLAG peer-link, and such ports/VLANs need to obtain connectivity via an 
alternative other than the MLAG-connected ports/VLANs.
Port-channel numbers within a VPC must be identical.
MLAG non-redundant ports do not run spanning tree and should be used and 
connected with caution. It is recommended that these ports be configured 
and used as routing interfaces on point-to-point links and only configured 
with VLANs that are not part of the MLAG domain.
MLAG peer switches must be the same model and have the same port count 
and module occupancy (if modules are used in the MLAG domain). 
Specifically, a port referred to on the secondary must be present on the master 
to be accepted for configuration. This is due to the table sizes (ARP, FDB, 
etc.), where the primary switch may learn more MAC addresses than the 
secondary switch and then, upon failover, the secondary will not be able to 
forward traffic to all of the addresses supported by the primary switch. It is a 
requirement of a port-channel that the link members operate at the same 
duplex and speed settings. In addition, copper ports have larger latencies than 
fiber ports. If fiber and copper ports are aggregated together, packets sent over 
the fiber ports would arrive significantly sooner at the destination than 
packets sent over the copper ports. This can cause significant issues in the 
receiving device, as it would be required to buffer a potentially large number 
of frames. Devices unable to buffer the requisite number of frames will show 
excessive frame discard.
Routing is not supported across multiple MLAGs (i.e., in two-tier topology). 
This is a fundamental limitation of MLAG, which is intended as a 
replacement for other, less efficient L2 topologies. Should a multitier L3 
topology be desired, other well established and well understood techniques,