DELL N3000 User Manual

Configuring Link Aggregation

The status outputs of the various VPC commands are self-explanatory. Both 

the configured and operational status is shown in the outputs. Additional 

commands are shown below that may be useful in troubleshooting MLAG 

configuration or operational issues. All of the commands below are run on the 

MLAG primary switch except as noted otherwise.

MLAG-Peer-A(config)#show vpc brief

VPC admin status............................... Enabled

Keep-alive admin status........................ Enabled

VPC operational status......................... Enabled

Self role...................................... Primary

Peer role...................................... Secondary

Peer detection admin status.................... Disabled

Peer-Link details

-----------------

Interface...................................... Po1

Peer-link admin status......................... Enabled

Peer-link STP admin status..................... Disabled

Configured VLANs............................... 1,10

Egress tagged VLANs............................ 10

VPC Details

-----------

Number of VPCs configured...................... 1

Number of VPCs operational..................... 1

VPC id# 1

-----------

Interface...................................... Po2

Configured VLANs............................... 1,10

VPC interface state............................ Active

Local Members        Status

-----------------    ------

Gi1/0/23             Up

Peer Members         Status

----------------     ------

Gi1/0/23             Up