Cabletron Systems FDDI User Manual
Chapter 3:
Installation/Removal
7F06-02 FDDI SmartSwitch Interface Module User’s Guide
3-3
3.3
INSTALLING/REMOVING THE 7F06-02 MODULE
The following procedure details the installation and removal procedure
for the 7F06-02 module.
for the 7F06-02 module.
3.3.1
Installing in the 7C03 SmartSwitch
The 7F06-02 Module is installed in the 7C03 MMAC SmartSwitch
using the following steps and referring to Figure 3-2.
using the following steps and referring to Figure 3-2.
Note:
The left-most slot in the 7C03 MMAC SmartSwitch is reserved for
the 7X00 SmartSwitch Module.
the 7X00 SmartSwitch Module.
Note:
Before installing the 7F06-02 module, attach the antistatic wrist
strap included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
strap included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. As a precaution, power down the MMAC 8 before beginning the
installation or removal of any modules. At the very minimum, the
7C03 must be pulled to disconnect it from the power source. Damage
to modules may result if this procedure is not followed.
7C03 must be pulled to disconnect it from the power source. Damage
to modules may result if this procedure is not followed.
2. Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling.
and cooling.
Ensure that the printed circuit board (PCB) is between the card guides,
slides in straight, and engages the backplane connectors properly.
slides in straight, and engages the backplane connectors properly.
4. Using a slotted screwdriver, tighten the top and bottom screws.
Figure 3-2
Installing the 7F06-02 Module in the
7C03 MMAC SmartSwitch
CPU
SN
Card
Guides
Guides