Cabletron Systems SmartCell 6A000 User Manual
SmartCell 6A000 User Guide 4-5
Switch Administration
Setting Up Routes
From SW2, enter
SmartCell ZX # show iisproute
Entry# Port# Metric Len Address
============================================================================
0 A4 1 104 39:00:00:00:00:00:00:00:00:00:14:41:80
SmartCell ZX #
5.
If clients on both switch SW1 and SW2 are within the same subnet, you can test connectivity by
pinging between clients.
pinging between clients.
IISP Routes Among Multiple Switches
Multiple IISP routes can be set up over a single physical link. Continuing with the example above, a third switch (SW3)
is added.
is added.
6.
Connect a cable between port B1 of SW2 and port B1 of SW3; then add an IISP route between B1
of SW2 and B1 of SW3 (see Figure 4-1).
of SW2 and B1 of SW3 (see Figure 4-1).
7.
Use the
add iisproute
command to add a third route from SW1 to SW3 over the existing cables.
On switch SW1, enter:
SmartCell ZX # add iisproute
ATMAdress() : 39:00:00:00:00:00:00:00:00:00:14:15:00
<SW3's netprefix
PortNumber(A1) :a4
<Port on SW1 attached to the cable from A4 on SW2
Metric(1) :
SmartCell ZX #
On switch SW3, enter
SmartCell ZX # add iisproute
ATMAdress() : 39:00:00:00:00:00:00:00:00:00:14:41:80
<SW1's netprefix
PortNumber(A1) :b1
< Port on SW3 attached to the cable from B1 of SW2
Metric(1) :
SmartCell ZX #
SW1 and SW3 are connected without using a dedicated physical connection between the two switches.
Note that a routing loop is created if SW1 and SW3 are physically connected with a cable and an IISP route is defined
over this physical link.
over this physical link.