Cabletron Systems 2H33-37R User Manual
2H23-50R/2H33-37R User’s Guide
B-1
APPENDIX B
FE-100TX, FE-100FX, AND FE-100F3
SPECIFICATIONS
The 2H23-50R supports three Fast Ethernet Interface Modules:
•
)
•
•
)
This appendix provides the specifications for these modules.
B.1
FE-100TX
The FE-100TX uses an RJ45 connector supporting Category 5
Unshielded Twisted Pair (UTP) cabling.
Unshielded Twisted Pair (UTP) cabling.
The slide switch on the FE-100TX determines the crossover status of the
cable pairs. If the switch is on the
cable pairs. If the switch is on the
X
side, the pairs are internally crossed
over. If the switch is on the
=
side, the pairs are not internally crossed
shows the pinouts for the FE-100TX in both positions.
Figure B-1
FE-100TX RJ45 Pinouts
NOTE
To ensure proper operation, use only Category 5 Unshielded
Twisted Pair (UTP) cabling that has an impedance between 85
and 111 ohms.
Twisted Pair (UTP) cabling that has an impedance between 85
and 111 ohms.
Position X
(crossed over)
(crossed over)
1. RX+
2. RX-
3. TX+
4. NC
2. RX-
3. TX+
4. NC
5. NC
6. TX-
7. NC
8. NC
6. TX-
7. NC
8. NC
Position =
(not crossed over)
(not crossed over)
1. TX+
2. TX-
3. RX+
4. NC
2. TX-
3. RX+
4. NC
5. NC
6. RX-
7. NC
8. NC
6. RX-
7. NC
8. NC
FE-100TX
10
16651_05
100
=
x