Cabletron Systems 2E43-51R User Manual
Chapter 5: Local Management
5-86
2E43-51/2E43-51R User’s Guide
•
Special Commands – Allow the user to exit from Network Tools. The
commands are done, exit, and quit.
commands are done, exit, and quit.
The commands are presented in the following format:
command:
Syntax:
Shows the required command format. It
indicates where arguments, if any, must be
specified.
indicates where arguments, if any, must be
specified.
Description:
Briefly describes the command and its uses.
Options:
Lists any additional fields in the appropriate
format which may be added to the command.
format which may be added to the command.
Example:
Shows an example of the command.
5.26.1
Built-in Commands
The built-in commands listed in this section activate functions on the LM
managed device or devices being accessed through Network Tools.
managed device or devices being accessed through Network Tools.
arp:
Syntax:
arp <options>
Description:
The arp command provides access to the ARP
(Address Resolution Protocol) cache, enabling
you to view cache data, delete entries, or add a
static route. Super-user access is required to
delete an entry or add a static route.
(Address Resolution Protocol) cache, enabling
you to view cache data, delete entries, or add a
static route. Super-user access is required to
delete an entry or add a static route.
NOTES
The conventions used in describing the commands in Network
Tools are as follows:
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
user is shown in bold Helvetica font
user is shown in bold Helvetica font
.
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.
key and c key simultaneously, designated as ^C here.