Cabletron Systems STHI User Manual
Accessing LM
Page 5-3
5.1.2
Console Cable Configuration
Connect the console cable to the STHI as follows:
1.
Attach the male RJ45 connector to the COM port of the STHI.
2.
Attach the female end to the 25-pin or 9-pin COM port on the terminal.
5.1.3
Entering LM
After configuring the LM terminal and properly attaching the cable to the
STHI, the user may access the Local Management interface.
STHI, the user may access the Local Management interface.
1.
Activate the console: power up the terminal, or run the emulator
program. After the STHI is fully booted, the STHI Password screen
shown in Figure 5-1 appears on the console’s monitor.
program. After the STHI is fully booted, the STHI Password screen
shown in Figure 5-1 appears on the console’s monitor.
Figure 5-1. Password Screen
2.
Enter a password. (There are two factory default passwords for
super-user access: “public” and a blank entry.) Then press the Return
key.
super-user access: “public” and a blank entry.) Then press the Return
key.
Passwords are user-definable and may be accorded varying degrees
of access to the functions of LM. Refer to Section 5.4, The SNMP
Community Names Screen
of access to the functions of LM. Refer to Section 5.4, The SNMP
Community Names Screen
If the password entry is invalid, the entry is cleared and the cursor returns
to the beginning of the password entry field. If the password is valid, the
associated access level in effect for the session is reported briefly on the
to the beginning of the password entry field. If the password is valid, the
associated access level in effect for the session is reported briefly on the
STHI LOCAL MANAGEMENT
Cabletron Systems, Incorporated
P.O. Box 5005
Rochester, NH 03866-5005
(603) 332-9400
P.O. Box 5005
Rochester, NH 03866-5005
(603) 332-9400
(c) Copyright Cabletron Systems, Inc. 1995
Flash Image Version: 1.00.00
Boot EPROM Version: 01.00.00
Board Revision: 112
Boot EPROM Version: 01.00.00
Board Revision: 112
Enter User Password: