Cabletron Systems 6E122-26 User Manual
General Configuration Screen
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
5-47
3.
Press ENTER. If the subnet mask is valid, the cursor returns to the
beginning of the Subnet Mask field. If the entry is not valid, the Event
Message Line displays “INVALID SUBNET MASK OR FORMAT
ENTERED”. Local Management does not alter the current value, but
it does refresh the Subnet Mask field with the previous value.
beginning of the Subnet Mask field. If the entry is not valid, the Event
Message Line displays “INVALID SUBNET MASK OR FORMAT
ENTERED”. Local Management does not alter the current value, but
it does refresh the Subnet Mask field with the previous value.
4.
Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in
ENTER. The warning screen shown in
displays.
5.
Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots
The changes are saved and the module reboots
5.15.3
Setting the Default Gateway
If the SNMP management station is located on a different IP subnet than
the 6E12X-26 and 6E13X-25, a default gateway must be specified. When
an SNMP Trap is generated, the 6E12X-26 and 6E13X-25 sends the Trap
to the default gateway. To set the default gateway, perform the following
steps:
the 6E12X-26 and 6E13X-25, a default gateway must be specified. When
an SNMP Trap is generated, the 6E12X-26 and 6E13X-25 sends the Trap
to the default gateway. To set the default gateway, perform the following
steps:
1.
Use the arrow keys to highlight the Default Gateway field.
2.
Enter the IP address of the default gateway using the DDN format.
For example: 134.141.79.121
3.
Press ENTER. If the default gateway entered is a valid format, the
cursor returns to the beginning of the Default Gateway field. If the
entry is not valid, the Event Message Line displays “INVALID
DEFAULT GATEWAY OR FORMAT ENTERED”. Local
Management does not alter the current value, but it does refresh the
Default Gateway field with the previous value.
cursor returns to the beginning of the Default Gateway field. If the
entry is not valid, the Event Message Line displays “INVALID
DEFAULT GATEWAY OR FORMAT ENTERED”. Local
Management does not alter the current value, but it does refresh the
Default Gateway field with the previous value.
4.
Use the arrow keys to highlight the SAVE command.
5.
Press ENTER. The Event Message Line at the top of the screen
displays “SAVED OK”.
displays “SAVED OK”.