Panasonic PT-F300N User Manual

49

Select [NEXT] on the IP address setting window to switch to the wireless setting window. 

Make the settings related to the wireless connection between the projector and the network.

 SSID

※

 

:  If the mode is [INFRASTRUCTURE

※

], enter the SSID registered at the access point. If the mode is 

[AD HOC], enter the same character string as that of SSID set on the computer to be connected.

 MODE 

: Select [AD HOC] or [INFRASTRUCTURE].

  AD HOC

※

 

:  Connect projector and computer directly without access point.

  INFRASTRUCTURE

※

  : Connect through access point.

 AUTHENTICATION  :  Set the user authentication method used by the network to be connected.

  OPEN 

:  Select when making a connection using [AD HOC], or when the access point authentication method is 

OpenSystem

※

.

  SHARED 

:  Select when making a connection using [AD HOC], or when the access point authentication method is 

Shared Key

※

.

  WPA-PSK

※

 

:  Select when the access point authentication method is WPA-PSK.

  WPA2-PSK

※

 

:  Select when the access point authentication method is WPA2-PSK.

 ENCRYPTION :  Select the encryption method to be used for communication between the projector and the network.

  NONE  

:  Select when transmit without encryption. It is selectable only when [AUTHENTICATION] is [OPEN] or 

[SHARED].

  WEP

※

  

: Select when ENCRYPTION is WEP.

  TKIP

※

   

: Select when ENCRYPTION is TKIP.

   

 

  Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].

  AES

※

   

: Select when ENCRYPTION is AES.

   

 

  Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].

※ “Glossary” (See page 65)

• If you are unable to connect to the wireless LAN through the access point even after performing the steps in “A Projector 

• IEEE802.1x is not supported.

• If you finished entering settings, press [NEXT].

SSID has to be entered in lower-case alphanumeric letters.