Atlantis Land A03-HP2001 User Manual

 

 

This manual contains important safety instructions. Please follow all instructions carefully during installation. Read this 

manual thoroughly before attempting to unpack, install or operate. 

 To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area, 

free of conductive contaminants. 

 Risk of electric shock, do not remove the cover. No user 

serviceable parts. Refer servicing to qualified service personnel.   

 Risk of electric shock, hazardous live parts inside this UPS can be 

energized from the battery supply even when the input AC power is 

disconnected. 

 Risk of electric shock, Battery Circuit is not isolated from AC input; 

hazardous voltage may exist between battery terminals and 

ground. Test before touching.

This is a Class A-UPS Product. In a domestic environment, this 

product may cause radio interference, in which case, the user may 

be required to take additional measures.   

The UPS is designed to be for use with computer loads only. 

 To prevent injury, do not carry with the handle of front cover when 

moving the UPS.

 

Inspect the UPS upon receipt. Notify the carrier 
and dealer if there is damage. The package is 
recyclable; save it for reuse or dispose of it 
properly. 
 

 
 

First, connect the UPS with Utility, then plug the 
loads into the outlets on the rear of the UPS. To 
use the UPS as a master “On/Off” switch, make 
sure that all of the loads are switch “On”. 
These UPS outlets provide battery power and 
surge protection to the equipment when utility 
voltage is outside acceptable limits. 
 
 
 
 
 
 
 
 
 
 
 
 
Caution: Do not connect a laser printer to the 
UPS outlets.   

Connect the supplied interface cable (RS-232 or 
USB) to the interface port on the rear of the UPS 
and the computer interface port. See software 
installation guide in the CD-ROM (Optional) for 
installation purpose. 

 

Connect a 10 base-T / 100 base-T network cable 
into the RJ-45 network surge protection “IN” jack 
on the rear of the UPS. Connect from the “OUT” 
jack with network cabling to network equipment. 
 

 

1. Connect the UPS to the wall receptacle. 
2. Push the “On” Switch on the front panel of the UPS until 4 LEDs (LCD) are lit then extinguished 

and release the “On” Switch.   

3. The Backup mode LED (Amber) lights up and the UPS is under self-test mode now. If Utility is 

normal, the UPS will run under Utility mode (Green LED) after its self-test is complete. On the 
contrary, the UPS will run under Backup mode and the buzzer alarms every 2 seconds in case of 
blackout or over/under voltage. 

1. The UPS “On” will not be executed if the above procedure is not done completely, which means 

the button is released before all 4 LEDs (LCD) are extinguished.   

2. The UPS will remain at “NO” output, if the start-up operation is not proceeded properly even 

though the Input Power Cord is connected to the wall receptacle.   

 

 Plug the UPS into the wall receptacle to charge the UPS for over 10 

hours after initial installation. 

IN

O U T