MGE UPS Systems ESV 8+Rack User Manual
MGE UPS SYSTEMS
Pulsar ESV 8+Rack/11+Rack/14+Rack/22+Rack
: 86-153523-00
13
c.
Vac IN
mains
outlet
outlet
5
Network Protection
IN
OUT
1
2
MGE UPS SYSTEMS, Inc.
7b
7a
7
8
getting started
installation
■
observe the safety rules indicated at the
beginning of this document.
preliminary checks
■
check that button
3
"
" on
the front is not pushed in;
■
check that rating shown on identification
plate
10
corresponds to the input volt-
age specification and power requirement of
the load.
the load.
connections
■
power connections:
■
■
use the UPS input cord to supply input
power to Pulsar as shown.
■
serial connections:
If you wish to use the functions of the
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
14
to the communication port 9 .
Connect the other end to a serial port of a
computer system.
computer system.
■
computer network protection:
If you wish to use the network line filtering
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
Connect the UPS input cord 5
to a near-
by power outlet.
For the ESV8+
For the ESV8+
Rack, the input cord is not
attached to the UPS. Connect the input
cord to the UPS input recepticle 4 , as
shown on page 7, and to a nearby power
outlet.
cord to the UPS input recepticle 4 , as
shown on page 7, and to a nearby power
outlet.
■
■
use included IEC cords
8
to connect
the computer loads to output sockets
7 ,
7a
and
7b
.
Note 1:
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button
3
"
" .
Note 2:
The batteries will provide full back-up time
after approximately 8 hours of recharge time.
The batteries will provide full back-up time
after approximately 8 hours of recharge time.
Note 3:
The rating of the input power cord must not be
less than the nominal input rating of Pulsar.
The rating of the input power cord must not be
less than the nominal input rating of Pulsar.