Blomberg TKF 7230 User Manual

Page of 44
17 - EN
Filter drawer (for products 
equipped with a heat pump)
Lint and fibre that could not be caught 
by the cover filter are blocked in the filter 
drawer behind the kick plate. “Condenser
cleaning” warning light will light up 
periodically after a maximum 5 drying 
cycles as a reminder.
In order to get the best performance from 
your machine, clean the cover filter and the 
filter drawer after each drying cycle. There 
is a two-phase filter in the drawer. The first 
phase is the cover filter and the second 
phase is the filter sponge in the filter drawer.
To clean the filter drawer;
1  Pull out the filter drawer.
2  Clean lint, fibre, and cotton raveling by 
hand or with a soft piece of cloth.
3  Open the filter drawer by pressing the
red button.
4  Take out the filter drawer sponge.
5  If the sponge is covered with lint 
and fibers, it must be cleaned. Wash 
the sponge by hand to clean it and 
squeeze to drain excessive water. 
After washing the sponge, any remaining 
Cover filter
Lint and fibres released from the laundry 
to the air during the drying cycle are 
collected in the "Cover Filter". Such 
fibre and lint are generally formed during 
wearing and washing.
Always clean the filter after each 
Drying process.
For Filter cleaning;
1  Take out the cover
2  Lift the Cover filter up to pull out.
3  Clean lint, fibre, and cotton raveling by 
hand or with a soft piece of cloth.
4  Place the filter back into its place.
For the condenser (products 
equipped with a condenser);
Hot and humid air in the condenser is 
cooled with the cold air from the room. Thus, 
the humid air circulating in your machine is 
condensed and then pumped into the 
tank. 
C
  Clean the condenser after every 20 
drying cycles or once a month.
To clean the condenser;
1  If a drying process has been carried 
out, open the door of the machine and 
wait until it cools down.
2  Unlock the 3 condenser locks after 
opening the kick plate. 
3  Pull out the condenser.
4  Clean the condenser with pressurized 
water and wait until the water drains.
5  Replace the condenser with the side 
labeled "Top" facing upwards. Lock 
the 3 condenser locks.
6  Close the kick plate cover.
6
   Maintenance and cleaning