Panasonic FZG1AABACRM User Manual
31
Useful Information
1
Connect the DVD drive to the USB port.
2
Start the Setup Utility.
A
Display “Charm” and touch - [Change PC settings] - [General].
B
Touch [Restart now] under “Advanced startup”.
C
Touch [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and touch top left of the screen while [Panasonic] boot screen is
displayed.
l
If the [Panasonic] boot screen is not displayed, turn on the computer while touching top
left of the screen.
l
If the password is requested, enter the Supervisor Password.
3
Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
At the confirmation message, touch [Yes].
4
Check the [UEFI Boot] setting of the Setup Utility.
[UEFI Boot] should be set to as follows.
When the recovery disc for Windows 8 is used: [Enabled]
When the recovery disc for Windows 7 is used: [Disabled]
When the recovery disc for Windows 8 is used: [Enabled]
When the recovery disc for Windows 7 is used: [Disabled]
5
Set the Recovery Disc into the DVD drive.
6
Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
7
Touch top left of the screen while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
l
l
If the password is requested, enter the Supervisor Password.
8
Touch [Exit], then double-touch your DVD drive in [Boot Override].
9
Double-touch [Yes]
.
The computer will restart.
10 Touch [Reinstall Windows] and touch [Next].
11
At the confirmation message, touch [YES].
12 At the License Agreement screen, Touch [Yes, I agree to the provi-
sions above and wish to continue!] and touch [Next].
13 When the recovery disc for Windows 8 is used, touch [Next].
When the recovery disc for Windows 7 is used, select the setting and
touch [Next].
l
[Reinstall Windows to the whole Hard Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to “To
change the partition structure” (è
page 21).
CPE02725ZA_FZ-G1mk1_8_7_OI_E.indb 31
2013/02/07 10:31:20