Kodak 1200i User Manual

- After loading media in the normal routine, it is best to perform a ‘perfect media load’. 
Hold the feed roller guide (round plastic guide) at 
right side with one hand and then simultaneously 
press the 

button. Drive 

media forward until it pulls against the media roll, 
keep holding (do not allow guide to rotate) for 
another 10 seconds or so - resistance is the key 
to pull the media straight.  
 

 the media guides should be pulled all the 

way out when loading media 

(see Caution 

above)

. Also, once the media is tight, driving media ‘forward’ aids in alignment. 

 

To activate the drying system, select 

. Scroll through available selections. 12 dryer 

modes are available; refer to dryer matrix label affixed to 
printer’s top cover or 

Installation Step #14 above

 for 

specific modes of operation. 
 

0 = OFF 
1 = Fans Only 
2 = Minimum, Fans On 
3 = Minimum  
4 = Heat Low, Fans On 
5 = Heat Low  
6 = Heat Medium, Fans On 
7 = Heat Medium  
8 = Heat High, Fans On 
9 = Heat High  
10 = Maximum, Fans On 
11 = Maximum 

 

The air plenum may be lowered to the maintenance position by removing 2 

locking pins and gently lowering plenum. The air plenum should be only be lowered 
when performing printer calibrations and replacing cartridges. 
 

The air plenum may also be completely removed for certain media print 

applications (i.e. 50” bond media) where the media becomes obstructed by the air 
plenum. Contact technical support for assistance with removal.