Kodak 1200i User Manual
KODAK
1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide
43
2. For visible ink starvation (resembling large horizontal areas of ink dropout; no
error condition displayed on control panel) first verify ink system flow and
pressure are adequate (no bubbles greater than 1 cm in size within ink tubing
should be visible) and check general cartridge health (via color test & prime
pattern). Perform ‘System Prime’ (must have firmware version 2.1.0 loaded and
the new service station must be installed), select:
error condition displayed on control panel) first verify ink system flow and
pressure are adequate (no bubbles greater than 1 cm in size within ink tubing
should be visible) and check general cartridge health (via color test & prime
pattern). Perform ‘System Prime’ (must have firmware version 2.1.0 loaded and
the new service station must be installed), select:
UTILITY MENU – PRIME MENU – SERVICE STATION MENU – SYSTEM
PRIME
PRIME
. Activation of the System Prime will fully recharge the entire ink system in
~60 seconds (also assumes factory set service station height is correct and the
service station shim is installed properly) and helps correct ‘MAX INK TEMP
errors’ and general cartridge ink depletion problems 90% of the time.
service station shim is installed properly) and helps correct ‘MAX INK TEMP
errors’ and general cartridge ink depletion problems 90% of the time.