Sony UP-D75 User Manual

O

per

at

ion

Before Printing

10

Open the tray cover and place the paper in the paper 
tray.

The number of the paper is the same as the number of the 
paper that one roll of the ink ribbon can afford. Usually 
the ink ribbon and paper have run out at the same time. 
However, even when either the ink ribbon or the paper 
has run out, replace both the ink ribbon and the paper 
with new ones. When you load the paper, pay attentions 
to the following.
• The paper tray holds up to the total number of sheets 

contained in a package sheets of paper. If you exceed 
this limit, paper jams may occur. Also, do not place 
different types of paper in the tray. If you do, paper 
jams may occur.

• If you load the paper that is not compatible with the 

ink ribbon used, the gray balance may be changed.

• Load the paper so that it lays flat in the paper tray. If 

the paper is curled, it will overflow the paper tray and 
the printing position may shift. If this happens, load 
fewer sheets in the paper tray.

• Set the spacer according to the size of the paper, and 

then place the paper in the paper tray. Doing so may 
cause a paper jam or malfunction.

Close the tray cover and slide the paper tray into the 
printer until it clicks into place.

• Avoid storing the paper in a location subject to:

– high temperatures
– high humidity
– excessive dust
– direct sunlight

• Use the original package for storing unused paper.

Reverse side with printed logos

Print surface 
protection 
sheet

Riffle the paper.

Place the paper in the 
paper tray with the 
printing surface (shiny 
side with no legends) and 
its protection sheet facing 
down.

Pull up the tab and 
set the spacer 
according to the 
size of the paper.