Avery 676 User Manual
User Manual Model 676 LOKPRINT®
Printer Operation •
••
• 13
Printer Operation
Loading Stock
SUPPLY
HEAD 3
STOCK
HEAD 2
SUPPLY
INK
FABRIC
WEB GUIDE
HEAD 2
TAKE-UP
HEAD 2
DRIVE / AUX
INK
HEAD 3
HEAD 3
TAKE-UP
HEAD 1
TAKE-UP
HEAD 1
HEAD 1
SUPPLY
Figure 4 - LOKPRINT® Threading Diagram
Loading Stock For The First Time
1) Adjust the unwind width wider than the roll of stock to be loaded. Set the stock
roll on the unwind between the guides with the stock unwinding from the top
clockwise. Adjust the unwind width down to the stock size with the outer guide
contacting the roll. Turn the knob an additional ½ turn clockwise. This will
activate the constant backpressure device.
clockwise. Adjust the unwind width down to the stock size with the outer guide
contacting the roll. Turn the knob an additional ½ turn clockwise. This will
activate the constant backpressure device.
2) Adjust the web guides to a width wider than the stock.
3) Remove the tape or pull the glued end of the stock loose from the supply roll of
stock. Pull off about 2 feet (.5 m) of stock to thread it through the printer.
NOTE: If the material was glued to the core, cut off all material that has glue on any
surface.
4) Open the hinged cover to the machine.
5) Open all print heads that are in use by pulling the release knob and then rotating
the print heads into the open latched position. The print stations have a pin in
the rear to hold them open.
the rear to hold them open.