Epson TM-FX2180 User Manual

After you select the factory setting, you see the Main menu.

Program : J******          Setting : *****
 9 pins      VR 0  =  0         VR 1  =  0         VR 2 = 0

       [    Main MENU    ]
   (1)  Bi-d Adjust                     (6) Envelope
   (2)  FF paper                        (7) ---- N/A ----
   (3)  A3 Cut sheet               > (8) -- SUB MENU  
   (4)  A4 1P Cut sheet
   (5)  A4 6P Cut sheet

6. 

Use the 

↑

 or 

↓

 key to highlight SUB MENU and press Enter. You see

the following submenu:

Program : J******          Setting : *****
 9 pins      VR 0  =  0         VR 1  =  0         VR 2 = 0

       [    Sub MENU    ]
   (1)  Memory SW Print          (6) EEPROM Print
   (2)  EEPROM Reset            (7) -- EXIT
 >(3)  TPE Adjust  
   (4)  Pitch     1P
   (5)  Pitch   20P 

7. 

Use the 

↑

 or 

↓

 key to highlight TPE Adjust and press Enter.

8. 

Insert an A4-size sheet of paper into the printer’s rear paper guide.
Make sure the paper is positioned in the portrait orientation. The TPE
check pattern and the current TPE position value is printed, as shown
in Figure 5-19.

9. 

Measure the distance from the top of the paper to the 0 level line, as
shown below. Check whether the distance equals 0.335 inches

±

 0.020 inches (8.5 mm 

±

 0.5 mm).

-9        -6      -3        0 

   3 

 6 

9 

TOF

TPE position = 00,

After the page is printed, you see the following menu:

 

< TPE adjustment >

 

      TPE Pos. = 0

Exit 

Print 

        Value 

Write 

Default

[ESC]  [SPACE]   [      (0-9)]     [RET] 

[HOME] 

10. 

If your TOF measurement is not equal to 0.335 inches 

±

 0.020 inches

(8.5 mm 

±

 0.5 mm), use the 

↑

 or 

↓

 key to change the TOF value. Then

press Enter.