Emulex NQ0V-NT+ User Manual

We recommend writing down the following parameters from the Setup 
Section in Chapter 2.  Refer to them during the installation procedure. 

Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____ 

Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___ 

IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___ 

TCP port _______ (parallel port) 

TCP port _______ (parallel port) 

TCP port _______ (serial port)   

TCP port _______ (serial port) 

Telnet port number _______ 

 

RCF port number _______ 

Have the TES & LAN Server diskette or the CD-ROM ready for installation. 

Check the system configuration before installing Print Manager for  TCP/IP 
printing. Every server and client must have the TCP/IP stack loaded before 
the server or client can send a print job to the printer server. 

Verify OS/2 LAN Server is installed with the TCP/IP protocol stack. 

1)  Verify that a directory containing TCP/IP libraries and applications 

exists on the system. 

2)  If this entry is not present, refer to the LAN Server documentation for 

information on installing and enabling the TCP/IP protocol stack. 

Verify the network interface card (NIC) is configured for TCP/IP. 

3)  Run the LAN Adapter and Protocol Support Utility. 

4)  Select C

ONFIGURE

. 

5)  In C

URRENT 

C

ONFIGURATION

 box, an entry for IBM TCP/IP protocol 

should be listed under each appropriate adapter or interface card (NIC).   

6)  If this entry is not present, refer to LAN Server documentation for 

information on how to configure and enable the TCP/IP protocol stack.