Vidikron 100 User Manual

8

 

Wired input from an external remote control.

 

Connection for an external RS-232 controller device to place the Projector under system automation control.

 

Reads out all relevant status information of the Projector at all times.  Can be used instead of the On Screen  

 

Display. Indicates the model number, current source, scan rate (resolution) and aspect ratio.

 

Use to direct select aspect ratios or move the menu cursor Up in the On-Screen Display. When no menus are  

 

present  on-screen, the UP button will toggle you through aspect ratios in the following order:

 

Anamorphic → Standard (4:3) → Letterbox → IntelliWide

 

Used to direct select inputs or move the menu cursor Left in the On Screen Display. When no menu is present on- 

 

screen, the LEFT button will toggle you through the different sources, in the order of:

 

HD Pass Thru 2 → HD Pass Thru 1 → DVI 2 → DVI 1 → HD/RGB2 → HD/RGB1 → Component SD →

 

S-Video 2 → S-Video 1 → Composite

 

Use to direct select aspect ratios or move the menu cursor Down in the On-Screen Display. 

 

When no menu is present  on-screen, this button will toggle you through the different aspect ratios.

 

IntelliWide → Letterbox → Standard (4:3) → Anamorphic

 

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

 

Used to direct select inputs or move the menu cursor Right in the On Screen Display.When no menus are present  

 

on-screen, the RIGHT button will toggle you through the different sources, in the order of:                                        

             Composite → S-Video 1 → S-Video 2 → Component SD → HD/RGB 1 → HD/RGB 2 → DVI 1 → DVI 2 →

 

HD Pass Thru 1 → HD Pass Thru 2

 

Pressing the MENU button will bring up the main menu. Also, if you are in an adjustment mode or function,  

 

pressing MENU will bring the menu back one level.

 

Receives the IR commands from the remote.

 

Disconnects or applies main power to the processor.

 

Press once to toggle on from Standby mode to On mode, a second time to place into Standby mode.

 

For a discreet on or off command, you can use the direct access buttons on the remote control.