Epson EB-Z11000W User Manual

Check

Remedy

Are the Sync.

 and Tracking

 settings adjusted correctly?

(Only when projecting computer images)

Press the [Auto] button to perform automatic adjustment. If the images are not adjusted correctly even after performing
automatic adjustment, you can also make adjustments using Sync. or Tracking in the Signal menu.

s

 - Sync., Tracking 

Is Auto Setup set to On? (Only when projecting computer images) Depending on the input signal, images may be misaligned according to auto setup. If this happens, set Auto Setup to

.

s

 Signal - Auto Setup 

When Auto Setup is set to Off, the signals are stored once they are connected. Set Auto Setup to On or Off every time
you input a new image signal.

Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)

The image may be collapsed if the Resolution on the Extended menu and the resolution of the projected image are not
the same.
If the image is collapsed, set the Resolution to Auto.

s

 Signal - Resolution 

Check

Remedy

Is the Screen setting correct?

Make the appropriate Screen setting for the screen being used.

s

Is the aspect adjusted correctly?

Press the [Aspect] button on the remote control to select an aspect suitable for the input source.

s

Is the image still being enlarged by E-Zoom?

Press the [Esc] button on the remote control to cancel E-Zoom.

s

Is Scale set to On?

Set Scale to Off in the Signal menu.

s

 Signal - Scale 

Is the image position adjusted correctly?

(Only when projecting analog RGB signals input from the Computer input port or the BNC input port)
Press the [Auto] button to adjust the display position.
You can also adjust the position in the Signal menu.

s

 Signal - Position 

Is the computer set for dual display?
(Only when projecting computer images)

If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.

s

 Computer video driver documentation