Sharp XR-20S User Manual

• Make sure that you remove the lamp unit by

the handle. Do not touch the glass surface of
the lamp unit or the inside of the projector.

• To avoid injury to yourself and damage to the

lamp, be sure to carefully follow the steps
below.

• Do not loosen other screws except for the

lamp unit cover and lamp unit.

Press SSTANDBY/ON on the pro-
jector or eSTANDBY on the re-
mote control to put the projector
into standby mode.

• Wait until the cooling fan stops.

• Do not remove the lamp unit from the projec-

tor right after use. The lamp and parts around
the lamp will be very hot and may cause burns
or injury.

• Unplug the power cord from the AC

socket.

• Leave the lamp until it has fully cooled

down (about 1 hour).

• Turn the projector over. Loosen the user

service screw (1) that secures the lamp
unit cover. Remove the lamp unit cover
(2).

Lamp unit
AN-XR20LP
(for XG-MB55X/
XR-20X/XR-20S)
AN-XR10LP
(for XR-10X/XR-10S)

AC socket

User service screw
(for lamp unit cover)

STANDBY/ON button