Benq PE6800 User Manual

  Setting Up Your Projector

Setting Up Your Projector 

Preparations

1.

Remove the lens cap.

2.

Turn all of the connected quipment on.

3.

Plug the supplied power cord into the AC inlet on the rear of 
this unit. 

4.

Plug the power cord into a wall socket and turn the wall 
switch on.

5.

Turn on the main power switch at the rear of this unit (next to 
the AC inlet). The POWER light will light up in orange. Press 
POWER ON/OFF key on the remote control or STANDBY/
ON key on the projector for ONE second to turn the 
projector on.

Adjust the Height

There are four adjustment screws on the bottom of the projector. These adjustment screws change the image 
height and projection angle. They can lift the projection angle by up to 15 degrees. To adjust the projector:

1. Press the left and right buttons near the front of the 
projector and lift the front of the projector slightly, to 
approximately the correct position for your screen.

2. Screw the height adjustments to fine-tune the vertical angle.