ZyXEL Communications P-2302HWL-P1 Series User Manual
P-2302HW/HWL-P1 Series User’s Guide
Chapter 8 NAT
135
Figure 67 Network > NAT > Port Forwarding
Each field is described in the following table.
Table 55 Network > NAT > Port Forwarding
LABEL
DESCRIPTION
Default Server
Setup
Setup
Default Server
Enter the IP address of the server to which the ZyXEL Device should forward
packets for ports that are not specified in the Port Forwarding section below or in
the Management > Remote MGMT screens. Enter 0.0.0.0 if you want the ZyXEL
Device to discard these packets instead.
packets for ports that are not specified in the Port Forwarding section below or in
the Management > Remote MGMT screens. Enter 0.0.0.0 if you want the ZyXEL
Device to discard these packets instead.
Port Forwarding
#
This field is a sequential value, and it is not associated with a specific rule. The
sequence is important, however. The ZyXEL Device checks each rule in order, and
it only follows the first one that applies.
sequence is important, however. The ZyXEL Device checks each rule in order, and
it only follows the first one that applies.
Active
Select this to enable this rule. Clear this to disable this rule.
Name
This field displays the name of the rule. It does not have to be unique.
Start Port
This field displays the beginning of the range of port numbers forwarded by this
rule.
rule.
End Port
This field displays the end of the range of port numbers forwarded by this rule. If it
is the same as the Start Port, only one port number is forwarded.
is the same as the Start Port, only one port number is forwarded.
Server IP Address This field displays the IP address of the server to which packet for the selected
port(s) are forwarded.
Modify
This column provides icons to edit and delete rules.
To edit a rule, click the Edit icon next to the rule. The NAT Port Forwarding Edit
screen appears.
screen appears.
To delete a rule, click the Remove icon next to the rule. All the information in the
rule returns to the default settings.
rule returns to the default settings.