ZyXEL Communications P-334W User Manual

Prestige 334W User’s Guide 

WAN Screens 

 

9-11 

Allow between WAN 
and LAN 

Select this check box to forward NetBIOS packets from the LAN to the WAN and 
from the WAN to the LAN. If your firewall is enabled with the default policy set to 
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall 
rule that forwards NetBIOS traffic. 
Clear this check box to block all NetBIOS packets going from the LAN to the WAN 
and from the WAN to the LAN. 

Allow Trigger Dial 

Select this option to allow NetBIOS packets to initiate calls. 

Apply 

Click Apply to save your changes back to the Prestige. 

Reset 

Click Reset to begin configuring this screen afresh. 

To change your Prestige’s WAN MAC settings, click WAN, then the WAN MAC tab.  The screen appears 
as shown. 

 

The MAC address screen allows users to configure the WAN port's MAC address by either using the factory 
default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the 
factory assigned default MAC Address. 
Otherwise, click Spoof this computer's MAC address - IP Address and enter the IP address of the 
computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be 
copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting or upload 
a different ROM file.

  It is recommended that you clone the MAC address prior to hooking up the WAN Port.