ZyXEL Communications P-312 User Manual
P312 Broadband Security Gateway
4-6
Remote Node Setup
4.2 Editing TCP/IP Options (with Ethernet Encapsulation)
Move the cursor to the Edit IP field in Menu 11.1, then press the [SPACE BAR] to toggle and set the
value to Yes. Press [Enter]
value to Yes. Press [Enter]
to open Menu 11.3 - Network Layer Options.
Figure 4-4
Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 4-4
Remote Node Network Layer Options Menu Fields
Field
Description
Example
IP Address
Assignment
Assignment
If your ISP did not assign you an explicit IP address, select
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.
Dynamic
IP Address
If you have a Static IP Assignment, enter the IP address assigned
to you by your ISP.
to you by your ISP.
IP Subnet
Mask
Mask
If you have a Static IP Assignment, enter the subnet mask
assigned to you.
assigned to you.
Gateway IP
Addr
Addr
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
assigned to you.
Network
Address
Translation
Address
Translation
Use the [SPACE BAR] to toggle between Full Feature, None, SUA
Only. See the NAT chapter for a full discussion on this feature.
Only. See the NAT chapter for a full discussion on this feature.
SUA Only
Metric
This field is valid only for PPTP/ PPPoE encapsulation. The metric
represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
3
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Single User Account= Yes
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle
Press Space Bar to Toggle