ZyXEL Communications G-120 User Manual

ZyXEL G-120 User’s Guide

Chapter 5 Access Point Mode Configuration

61

This chapter shows you how to configure your G-120 in access point mode.

To use your G-120 as an Access Point (AP), select AP Mode in any utility screen (refer to 

.

In access point mode, your G-120 allows you to set up your wireless networks without using a 
dedicated AP. 

This section describes the ZyXEL utility screens when the G-120 is in AP mode. 

Figure 38   ZyXEL Utility Menu Summary: AP Mode 

The following table describes the menus. 

To bridge your wired and wireless networks using the G-120, the following requirements must 
be met:

1 The G-120 must be installed on a computer connected to the wired network.
2 Either configure network sharing (refer to 

 for an example) or 

bridge the two interfaces (wireless and wired) on the computer.

Table 15   ZyXEL Utility Menu Summary: AP Mode

AP Mode

Link Info

Use this screen to see your current connection status, configuration and data rate 

statistics.

Configuration 

Use this screen to configure wireless LAN settings. 

MAC Filter

Use this screen to configure which computer(s) you want to access the wireless 

LAN through the G-120.