Extreme networks 4700 User Manual

Altitude 4700 Series Access Point Installation Guide

The use on UNII (Unlicensed National Information Infrastructure) Band 1 5150-5250 
MHz is restricted to indoor use only, any other use will make the operation of this 
device illegal.

The available channels for 802.11 b/g operation in the US are Channels 1 to 11. The 
range of channels is limited by firmware.

This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed 
to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures:

●

Reorient or relocate the receiving antenna

●

Increase the separation between the equipment and receiver

●

Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected

●

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may cause 
undesired operation.