RAD Data comm Modular Access Device with Integrated Router User Manual
Chapter 4 Configuration
FCD-IPM Installation and Operation Manual
4-24
Advanced Setup Menu
4. In the New Software File Name field, type the path and file name of the new
software version.
The IP address and the new software version file name can also be defined through
the Setup menu. Refer to Setup at the beginning of the chapter.
the Setup menu. Refer to Setup at the beginning of the chapter.
5. Press S to start the download process.
During the process, the new program code is downloaded to the Flash backup
partition, thus erasing its previous contents.
Upon completion, the newly downloaded Flash partition becomes active,
while the old version’s partition becomes backup. The device automatically
resets, running the new program stored in the active partition.
Upon completion, the newly downloaded Flash partition becomes active,
while the old version’s partition becomes backup. The device automatically
resets, running the new program stored in the active partition.
During the download process, a counter shows the number of packets that have
passed. Downloading can be interrupted at any time by pressing the ESC key.
XMODEM via Control Port (BOOT Manager)
Use this option to access the BOOT Manager via the control port. Refer to
passed. Downloading can be interrupted at any time by pressing the ESC key.
XMODEM via Control Port (BOOT Manager)
Use this option to access the BOOT Manager via the control port. Refer to
Appendix B
for more information on the Boot Manager.
Upload Device Parameters to TFTP Server
Select this parameter to save device configuration parameters into a file by
uploading to the TFTP server. This operation sends all unit parameters to the TFTP
server and will be saved under a filename that you specify.
uploading to the TFTP server. This operation sends all unit parameters to the TFTP
server and will be saved under a filename that you specify.
IP
FCD-IPM
Parameter File Download/Upload
TFTP Server
Figure 4-22. Downloading/Uploading Parameters
To upload device parameters:
1. Activate the TFTP server application connected to the unit via an IP network.
2. Configure the following IP parameters: IP address, IP mask and IP default
1. Activate the TFTP server application connected to the unit via an IP network.
2. Configure the following IP parameters: IP address, IP mask and IP default
gateway.
3. Select the TFTP upload option.
4. Enter the TFTP server IP address.
5. Assign a name to the configuration file you want to save on the server, for
4. Enter the TFTP server IP address.
5. Assign a name to the configuration file you want to save on the server, for
example V35_file.
6. Press S to start the upload process.
Note