Hughes R-BGAN User Manual

Page of 68
 
 
T
ROUBLESHOOTING
 
This section details the following: 
 
ƒ 
Some general hardware and software problems you may encounter in the installation 
and operation of the Satellite IP Modem along with the possible source of these 
problems and how to correct them. 
ƒ 
System fault codes and descriptions reported to you by the Satellite IP Modem on the 
Control Pad screens, along with their possible causes and solutions. 
 
G
ENERAL 
T
ROUBLESHOOTING
 
Problem Possible 
Cause 
Action 
Battery needs 
recharging. 
Charge the battery. Check Battery Light or Control Pad for 
charging indication. 
The battery is not 
inserted properly. 
Remove and reinsert the battery. Make sure the battery latch 
is in its farthest right hand position after the battery is inserted. 
The battery 
contacts are dirty or 
damaged. 
Check the battery contacts. Clean them if necessary. If you 
find any damage, replace battery. 
Satellite IP Modem 
will not switch on, 
or will not stay on 
when under 
battery power. 
The Modem was 
reset while under 
battery power 
When the Modem is reset while under battery power (no AC 
Mains connected), you must turn it back on manually. This is 
a normal operation for the Modem. 
SIM card or SIM 
card contacts may 
be damaged. 
Visually inspect the SIM card and SIM card contacts and 
return SIM card to your Service Provider if it is damaged. 
SIM card may not 
be present. 
Remove the SIM boot according to the instructions in 
QuickStart Wizard and verify that the SIM card is present. 
SIM card error. 
SIM card may be 
inserted incorrectly. 
Remove the SIM card and make sure that it is inserted 
according to the instructions in QuickStart Wizard.  
 
SIM card contacts 
may be dirty. 
Clean the SIM card contacts with a dry cloth. 
The correct 
interface (USB, 
Ethernet, Bluetooth) 
was not chosen. 
Follow the instructions in the QuickStart Wizard to select the 
correct interface on the Satellite IP Modem. 
The Control Pad 
will not launch 
when the ‘Launch 
Control Pad’ 
option is selected 
from the Launch 
Pad window. 
If the correct 
interface was 
chosen, the PC 
may not have been 
able to discover the 
Satellite IP LAN 
connection. 
Reboot the PC or go to a Command Prompt and enter 
“ipconfig /release” followed by “ipconfig /renew.” 
R-BGAN Satellite IP Modem User Manual 
 
 
 
42