ZyXEL Communications G-220 v3 User Manual

ZyXEL G-220 v3 User’s Guide

34 

Chapter 2 Tutorial

Note: Only one profile can be activated and used at any given time.

Figure 17   ZyXEL Utility: Profile Activate

8 When you activate the new profile, the ZyXEL utility goes to the Link Info screen while 

it connects to the AP using your settings. When the wireless link is established, the 
ZyXEL utility icon in the system tray turns green and the Link Info screen displays 
details of the active connection. 

9 Make sure the selected AP in the active profile is connected to the Internet. Open your 

Internet browser, enter 

http://www.zyxel.com

 or the URL of any other web site in the 

address bar and press ENTER. If you are able to access the web site, your new profile is 
successfully configured. 

10If you cannot access the Internet, go back to the Profile screen. Select the profile you are 

using and click Edit. Check the details you entered previously. Also, refer to the 
Troubleshooting section of this User's Guide or contact your network administrator if 
necessary.

In access point mode, your G-220 v3 allows you to set up your wireless network without using 
a dedicated AP. Refer to 

 for more 

information.

Note: At the time of writing this feature is not available on Windows Vista.
Note: With WZC, you cannot use the G-220 v3 as an access point.

After you install the ZyXEL utility and then insert the G-220 v3, follow the steps below to set 
up your G-220 v3 as an AP. 

1 Select AP Mode in any utility screen and wait for five seconds. The screen changes and 

displays as next. Under Status, you can view the current settings on the G-220 v3. In the 
Association List, you can see if any wireless clients have connected to your G-220 v3.