ZyXEL Communications ZyXEL AG-120 User Manual

ZyXEL AG-120 User’s Guide

66

Chapter 5 Access Point Mode Configuration

To bridge your wired and wireless network using the AG-120, the following requirements 
must be met:

1 The AG-120 must be installed on a computer connected to the wired network.

2 Either configure network sharing (refer to 

 for an example) or 

bridge the two interfaces (wireless and wired) on the computer.

3 Set the wireless station’s IP address to be dynamic if you want the wireless stations to 

access the wired network or the Internet through the AG-120. Refer to 

 

for how to configure your computer’s IP address.

Select the AP Mode check box and wait for about five seconds to display the screen as shown.

Figure 40   Access Point Mode: Link Info 

The following table describes the labels in this screen. 

Table 16   Access Point Mode: Link Info 

Status

SSID

This field displays the name that identifies your AG-120 in the wireless LAN 

network.

Current Channel 

This field displays the radio channel the AG-120 is currently using.