IBM 09-0572-000 User Manual

This appendix contains an alphabetical list of the error messages 
that may appear when you use the TokenDisk diskette 
Configuration and Diagnostic Program for the 3C619C adapter. 
For information about running the adapter’s diagnostic 
program, refer to Chapter 7, “Troubleshooting,” and to 
Appendix A, “Using the Configuration and Diagnostic Program.”

A diagnostic test name was found in the configuration file at 
line xxxx. Only configuration parameter variables are allowed. 
See the INSTRUCT.TXT file in the \DIAG subdirectory of this 
diskette for a description of the file format.

A lobe cable must be connected from the selected adapter 
to a retiming concentrator or MAU. The Open Adapter for 
Ring Operation Test and Adapter Wrap Test both take more 
than 30 seconds to complete their tasks.

A syntax error was found in the configuration file at line xxxx. 
The configuration file format is described in the 
INSTRUCT.TXT file in the \DIAG subdirectory of this diskette.

Adapter failed while trying to read the adapter configuration 
stored on the adapter. Save a new configuration to the adapter. 
If the problem persists, swap with a known good 3C619C and 
try again.

An adapter was configured for EISA mode, but the EISA 
configuration utility has not run yet. Exit this program, place 
your EISA configuration diskette in drive A, and reboot the PC.