ZyXEL Communications 4.04 User Manual
ZyWALL (ZyNOS) CLI Reference Guide
13
C
H A P T E R
1
How to Access and Use the CLI
This chapter introduces the command line interface (CLI).
1.1 Accessing the CLI
Use any of the following methods to access the CLI.
1.1.1 Console Port
You may use this method if your ZyWALL has a console port.
1 Connect your computer to the console port on the ZyWALL using the appropriate cable.
2 Use terminal emulation software with the following settings:
2 Use terminal emulation software with the following settings:
3 Press [ENTER] to open the login screen.
1.1.2 Telnet
4 Open a Telnet session to the ZyWALL’s IP address. If this is your first login, use the
default values.
Make sure your computer IP address is in the same subnet, unless you are accessing the
ZyWALL through one or more routers. In the latter case, make sure remote management
of the ZyWALL is allowed via Telnet.
ZyWALL through one or more routers. In the latter case, make sure remote management
of the ZyWALL is allowed via Telnet.
Table 3 Default Settings for the Console Port
SETTING
DEFAULT VALUE
Terminal Emulation
VT100
Baud Rate
9600 bps
Parity
None
Number of Data Bits
8
Number of Stop Bits
1
Flow Control
None
Table 4 Default Management IP Address
SETTING
DEFAULT VALUE
IP Address
192.168.1.1
Subnet Mask
255.255.255.0