ZyXEL Communications 4.04 User Manual

ZyWALL (ZyNOS) CLI Reference Guide

Use these commands to configure bridge settings on the ZyWALL.

The following table describes the values required for many bridge commands. Other values 
are discussed with the corresponding commands.

The following section lists the bridge commands.

Table 21   Bridge Command Input Values

This identifies an interface. 
1: WAN1
2: WAN2
3: LAN
4: Wireless card
5: DMZ
6: WLAN (ports in WLAN port role)

Table 22   Bridge Commands

bridge block 

<ipx|poe|ip|arp|bpdu|unknow> 

<on|off>

Blocks IPX, PoE, IP, ARP, BPDU, and/or unknown Ethernet 
frames from passing through in bridge mode.

B

bridge cnt clear

Resets the bridging statistics counter.

R+B

bridge cnt disp 

Displays the bridging statistics table.

R+B

bridge iface active <yes|no> 

Sets the ZyWALL to bridge mode or router mode. 

R+B

bridge iface address [ip-

address]

Sets the bridge mode management IP address.

B

bridge iface display

Displays the bridge mode interface settings.

B

bridge iface dns1 [ip-address]

Sets the bridge mode first system DNS server IP address.

B

bridge iface dns2 [ip-address]

Sets the bridge mode second system DNS server IP address.

B

bridge iface dns3 [ip-address]

Sets the bridge mode third system DNS server IP address.

B

bridge iface gateway [gateway-

ip]

Sets the bridge mode default gateway.

B

bridge iface mask [mask]

Sets the bridge mode network mask.

B

bridge rstp bridge disable

Turns off RSTP.

B