ZyXEL Communications 4.04 User Manual

ZyWALL (ZyNOS) CLI Reference Guide

Use these commands to configure CNM agent settings on the ZyWALL.

The following section lists the commands for this feature. 

Table 25   CNM Commands

cnm active [0:disable|1:enable]

Enables or disables the CNM service on the ZyWALL. 
After enabled, the ZyWALL communicates with the CNM 
server through ZyWALL’s WAN.

R+B

cnm sgid

Displays the unique ID received from the CNM server 
after the ZyWALL registered successfully.

R+B

cnm managerIp

Displays the CNM server's IP address.

R+B

cnm debug 

[0:disable|1:enable]

Controls whether the debugging information is displayed 
on the console. You must change the baud rate to 
115200 bps before enabling the CNM debug mode.

R+B

cnm reset

Resets the CNM service to the initial status on the 
ZyWALL. The ZyWALL will register itself to the CNM 
server again if the service is enabled.

R+B

cnm encry [none|des|3des] [key]

Displays or sets the encryption mode and key. 
The encryption key is 8 characters when the encryption 
mode is set to “DES”.
The encryption key is 24 characters when the encryption 
mode is set to “3DES”.

R+B

cnm keepalive 

<10~90>

Sets how often (in seconds) the ZyWALL sends a  
keepalive packet to inform the CNM server of its 
existence.

R+B

cnm version

Displays the CNM agent version.

R+B

cnm alarmqueue display

Displays the alert messages waiting to be sent to the 
CNM server.

R+B

cnm alarmqueue send

Sends all alert messages in the queue to the CNM server 
immediately and clears the queue.

R+B